iCharger 1010B+ is our mid level battery charger and conditioner. Outputting 10amp and 300 (true) watts. Charging 1-10 cell lithium batteries (lip, Life etc), 1-25 cell NiMh and NiCD and 2-36v Lead Acid Batteries.
Features at a glance:
Built In Resistance Meter: Determines which battery pack is the best, on its last legs etc.
PC USB Connectivity: Works with PC to plot discharge & charge curves. This allows very accurate analysis of battery power, voltage, condition and more.
Firmware Upgradable: All iChargers are firmware upgradable.
Far Better Accuracy: No more frustration with your charger giving you one reading and your battery pack doing something else.
On The Fly Parameter Settings: Change charge current, end voltage and safety cut-offs during a cycle. No more stopping and starting a cycle to make changes.
10 Memories: Store ALL settings for a battery. Memories can carry long names.
Monitor Function: Monitoring your batteries (from balance port) while in use or during its application. Useful to analyse the true power of the battery, running time, discharge graphs and much more!
Efficiency: iChargers have been proven to have 90% efficiency. Greater efficiency means more power for charging and no need for large heatsinks.
Noise: Built in fan only comes on when absolutely necessary and based on user set internal temperature settings.
Size: Smallest sized DC battery charger in comparison to its power rating.
Faster Charge Time: The more power (watts) a charger has, the more power it can supply to the battery. This charges the battery faster, also allowing for advanced charging techniques, such as parallel charging.
Regenerative Discharge: During a discharge cycle the charger will send the wasted energy back to the power source and charge this at the same time! The power source needs to be rechargeable, such as a 12v automotive battery. During regenerative discharge mode, the charger can discharge a battery at the chargers maximum discharge amps and watt rating.
All iChargers are DC powered chargers. For best options on powering the iCharger, please check our Bench Top Power Supplies.
Input Voltage: 10-18 Volts DC
Charge Current Range: 0.05 – 10.0 Amps
Discharge Current Range: 0.05 – 7.0 Amps
Maximum Charge Power Capacity: 300 watt
Balance Accuracy: <10mv
Lithium (LiPo/Lilo/Life) Battery Cell Count: 1-10 series
NiMH/NiCD Battery Cell Count: 1-25 Series
Pb (Lead Acid) Cell Count: 1-18 series (2-36v)
Battery Setup Memories: 10
Intelligent Temperature Control: Yes
PC Connect: USB Port
Dimensions (L*W*D): 143 x 97 x 26
1 x iCharger 1010B+
1 x USB Cable (Specific to iChargers)
2 x 4mm Banana Socket to Alligator Clip Adaptors (Red and Black)
1 x 4mm Banana Plug to Alligator Clips Charge Cable
1 x iCharger Temperature Sensor
1 x Mini CD ROM
Product brochure / datasheet can be downloaded by clicking the PDF icon just below the main image.
Balance board is not included with the iCharger 1010B+. We currently carry standard JST-XH, Polyquest / Hyperion and Thunderpower / Flightpower balance boards to suit the iCharger 1010B+ charger. Balance boards are available to purchase separately.
All our iCharger products carry a 12 Month Manufacturer Warranty. The warranty is void if damage is due to:
- Excessive heat from incorrect use or higher input voltage than designed for and clearly specified.
- Using the product incorrectly with incorrect battery products or power supplies.
- iCharger aluminium case opened by non iCharger recommended technician.